-
Using the Template print the text on the front of
your card. The font shown in the picture is an elegant font, Blackjack, which you can
download free here.
http://www.typadelic.com/blackjack.html
-
To attach the wider ribbon to the card, lay a strip
of double sided tape all the way across the card about 3.5cm from the
top and peel off the protective layer. Hold the ribbon taught in both
hands and lay onto the tape. This will make the ribbon lie straight and
flat. Fold the ribbon inside the card and attach the ends in the same
way across the inside the card for a neat finish.
-
Cut a 3cm square of Burgundy Handmade Paper, and a
3.5cm of gold pearlescent card. Stick the burgundy square onto the gold
square using Double Sided tape leaving an even border of gold.
-
Link two gold rings by gently bending them open
sideways and then closing them in the same way. Tie 3mm burgundy ribbon
through both rings in a single knot. Wrap the ribbon tied rings round
the layered burgundy and gold square and attach to the back with double
sided tape.
-
Now we are going to tear the mulberry paper into 5cm
squares using water. The water weakens the paper and allows you to tear
along the wet line giving a beautiful fluffy edge. Using a ruler, draw a
thin line of water with your brush. Make a strip 5cm wide and then using
the same technique make as many squares as you need. Be gentle when
tearing this delicate paper and you will get beautiful results.
-
Attach the mulberry square to the card with a glue
stick and layer the ring embellishment over it.
-
You can now print your insert using the Wedding
Crafter template and your beautiful invitation is finished.
